Inputs
|
- 64 wireless inputs. The wireless inputs are managed by the wireless module in the control unit and/or through RIVERRF via RS485.
- Are available in the control unit, with the reduction of wireless inputs, 8 wired inputs (16 with split function).
- On board zones can be configured as: NO, NC, balanced, split, extended split, triple balanced, fast.
|
Outputs
|
- Up to 64 programmable outputs with remote control function
- 12V fuse-protected power output for detectors
- Alarm relay output with C-NO-NC free from potential contacts with 3A@AC24V carrying capacity. The output can be configured
- Connector with 8 outputs for ETRREL modules that can be configured and remotely controlled
|
Users
|
- Advanced management of 32 users max; users can be assigned a proximity key or a remote control device
|
Areas/sectors
|
- Management of 4 areas with 4 sectors each
|
Control devices
|
|
User interface
|
- Graphic B/W LCD display, 128x65, with RGB backlight depending on operating conditions (adjustable)
- Backlit 20-rubber-key keypad
- Unit control via proximity key with partitioning function
- Low-consumption proximity key reader located at the centre of the sectors keypad (selectable)
- RF Monitor with graphic display
|
Serial line
|
- RS485 serial line for compatible devices connection
|
Clock
|
- Internal clock with backup battery
- Weekly timer
|
Wireless module
|
- FM 434 525 MHz receiver compliant with EN300220 (Class 2) and low consumption EN50131 with built-in antenna on PCB
- Low-consumption AM 868.300 MHz transmitter compliant with EN300220 and EN50131 standards with antenna integrated on the PCB
|
Events storage
|
- Historical memory with 1000 events capacity
|
Connectors
|
- MINIDIN connector for configuration and remote control (CP8/SER2 cable required)
- MINIUSB for programming, remote control and firmware upgrade with simplified mode
- Support of ETREIB interface via CP8/SER2 cable for connection to the standard konnex systems
- Connector for remote I66 proximity key readers.
|
Phone dialer
|
- Telephone number list, 16 numbers for voice calls, 2 numbers for digital calls, 4 numbers for remote assistance, 1 number for direct dial-out
- Digital dialler operating with ContactID and Fast Format protocols
|
Voice synthesis
|
- Voice synthesis module with 64 messages recordable by the installer, equipped with microphone and loudspeaker; it can be configured via USB and serial line for a total of 8 minutes recording time
- Messages can be recorded by using the suitable software module; they can also be recorded using a microphone connected to the PC audio board
|
GSM
|
- Remote interrogation via SMS with GSM module (optional)
- Sophisticated credit control system for rechargeable SIM cards when using MDGSMI / MDGSME optional modules
- The module allows the connection to the e-Connect platform (management, centralization, and supervision system service)
- Remote listening device controlled via SMS
|
LAN
|
- MDLAN Ethernet module (optional) for remote control and programming via TCP / IP
- The module allows the connection to the e-Connect platform (management, centralization, and supervision system service)
|
Internal siren
|
- Low-consumption built-in piezo siren for alarms and operating signals, volume adjustable
|
Functions
|
- Control of up to 15 sirens and 15 configurable actuators
- Temperature sensor with thermostat function, programmable hysteresis and calibration option
- MDTEMP wireless temperature detector to be used instead of the built-in detector or as external detector if necessary
- Daily/weekly thermostat function, with block boiler detection
- Emergency light function
|
Housing
|
- Plastic against opening and removal
- Black colour
|
Battery
|
|
Operating temperature
|
- From +5 to +40 °C (environmental class I)
|
Dimensions/weight
|
- W 268 x H 210 x D 63 mm
- 990g with well fixing bracket
|
Consumption
|
- 15,5mA (NO inputs) low consumption condition.
- 88mA with disconnected control unit and active phone dialer.
|
Power supply
|
- From power AC110-240V 50Hz ( MDPOWER module included)
|
Performance level
|
|
Standards
|
- User interface according to EN50131 with compliance options
- Compliance EN50131-3 grade 1, environmental class I°
- Compliance to R&TTE 1999/5/CE Standard and to ETSI EN 300220-3 and ETSI EN301-5-3+A1
|